The short answer
The dining light is hung at a height that lights the table without dazzling or blocking the view between diners, and its size should be clearly smaller than the table. The figure: between 55 and 70 cm from the table top to the base of the light, according to Louis Poulsen (2026), with a diameter of a third to a half of the width of the table. If the ceiling is higher than usual, raise the light a few centimetres and check with someone sitting.

Who this guide is for
For anyone about to hang a new light over the table in the dining room or living-dining room, or who already has one hanging and finds it too high, too low or too big.
The three criteria
1. Height above the table top
This is the measurement that changes the result the most. Too high, and the light scatters and the fitting loses its presence; too low, and it dazzles and cuts off conversation. It is measured from the table top to the lower part of the light.
2. Size relative to the table
The light should leave a clear margin to the edge of the table so that nobody bumps into it when standing up. On long rectangular tables, an elongated light or two small ones in a line tends to work better than a single round one.
3. Type of light
An alabaster or fabric shade gives a warm, diffuse light; open glass gives more direct light. Install a dimmer: the same light then works for dinner and for lingering at the table afterwards. The dining light is one of the three layers of light in the living room.
Evidence: reference measurements
According to Louis Poulsen (2026) and the product page of the Duna pendant light, these are the reference measurements for a light over a dining table:
| Measurement | Value | Source |
|---|---|---|
| Distance from the table top to the base of the light | 55 to 70 cm | Louis Poulsen (2026) |
| Diameter relative to the width of the table | a third to a half of the width | Louis Poulsen (2026) |
| Distance between lights if there are several | about 80 cm between centres | Louis Poulsen (2026) |
| Measurements of the Duna pendant light | 42 cm wide and 53 cm high | Product page (2026) |
Example with the Livia table and the Duna pendant light
The Mesa Livia measures 180 × 90 cm and seats 6 comfortably. With a single Duna pendant light (42 cm wide and 53 cm high) centred on the axis of the table, the diameter stays below half the 90 cm width, within the reference of a third to a half. It is first hung temporarily, with the table in place and someone sitting, and adjusted until the base is out of the line of sight of the person opposite. Then the final height is fixed.
Limits
This guide does not replace an electrician, and it does not cover the electrical installation, the ceiling fixing or the load it can bear. Nor does it deal with sloping ceilings, exposed beams or tables with a kitchen island, which call for a study of each case. Some designer lights have a long delivery time: confirm the lead time before planning the work.
Pieces from the shop
- Lámpara de colgar Duna: 42 cm wide and 53 cm high
- Mesa Livia: oval, 180 × 90 cm with a ceramic top, seating 6 comfortably and up to 8
Next step
To see alabaster and designer lights and wall lights, visit the Zach & Decor collections. If you want to organise all the lighting in your living room, read how to light a living room in layers.
Related questions
How many lights do I hang over a long table
It depends on the length. A table for six takes one central light; a longer one usually calls for two or three small ones in a line or an elongated light.
Do I need a dimmer
It is not compulsory, but it is the cheapest improvement: it allows a strong light for eating and a warm, low one for lingering afterwards.
Can I hang the light if the table is not centred
It is best to centre it over the table, not over the room. If the table is off-centre, the light goes over the table and the general lighting is made up with other layers.
Sources
- Louis Poulsen (2026): height above the table top, diameter and distance between lights



